Washer Woes: Part 2 – How To Replace A Water-inlet Valve


Having your clothes wash is all about drinking water equilibrium and range of detergent. If you have issues controlling your washer water temperature, then your water inlet valve could be responsible.

This Informative Article follows upon the first post: Washer Woes: Part 1 – Water Temperature. If you’ve read Part You’re still getting issues controlling your washer water fever, then keep reading to learn to examine, analyze, and replace your drinking water inlet valve.

Drinking water enters the drinking water heater valve through 2 hoses which originate out of the hot and cold water heaters in the wall. Solenoids inside the water inlet valve respond to this temperature selector change and make the selected water temperature. The mixed hot and cold drinking water exits the water heater valve through a standard hose, so filling your washer together with the suitable temperature of water.

Never ever try any repairs or maintenance on your own washer without any making sure the capability to your washer has been disconnected – you might be injured if the energy is not emptied.

The drinking water inlet valve is located in the back part of one’s washer (inside the cupboard ). Prior to assessing the water heater valve, carefully check the water flow. Shut off the water taps (in the wall) and disconnect the hoses from the back of the washer. Put the compacted conclusion of every hose at a skillet and twist to the ground. Check the stream of water and also to be certain the hoses are not blocked KP-LOK needle valves.

In the event the drinking water flow appears to be correct, remove and analyze the water heater valve. The valve is kept in position by just two screws. Remove the screws then disconnect the valve’s washer fill hose by loosening the clamp which holds the nozzle in place on the valve.

Given the valve is removed, utilize a tiny, flat-head screwdriver to pop out the valve’s inlet screens. Thoroughly examine and clean any debris out of those screens. Take care not to hurt the screens – they cannot be changed. If the screens are free of debris, then the very next thing to do is always to check the valve.

To check the water heater valve, then locate the cables attached with the terminals on each solenoid. Label the wires ahead of removal which means it’s possible to remember how to reconnect them. The cables are secured in place by alloy straps. When disconnecting the wires, then use needle nose pliers to remove the connector from the terminal. Twist the connector, not the wire. If the terminals and connectors are rusty or corroded, replace valve.

In the event the links are all fine, examine your water inlet valve to get joys. You certainly can do that using a multitester. Set your multitester to the ohms immunity climb X1.

Every solenoid includes 2 terminals. Test a single solenoid in a period by simply taking all one’s meter probes and touching you to each terminal. Readings might be different for every manufacturer or version, but in the event that you buy a consequence of infinity, then the solenoid is harmed and also the valve should really be replaced.

To displace the old valve with a brand new one, connect the fill hose to the new valve and then fasten it in place with the screws. Attach the wires to the solenoid terminals, and the water cold and hot water hoses to the valve openings. If everything is all procured, turn to the water. Check the drinking water heater valve and hoses for leaks just before turning to your washing machine and operating it by means of an cycle.

Some times there isn’t any style of figuring out what is wrong with your water inlet valve and replacing it may function as the sole solution. In the event you find this fixing difficult todo or when you have no an ohm meter or even a multimeter, then contact a service technician.

No comments yet

leave a comment